Image Areas | Basic > Z Index (Layer Order)

• Related Articles

• Image Areas | Strategies for dealing with angled image areas

  Overview The purpose of this article is to recommend some approaches that can be used when a rotated or angled image area is required as part of a design on a product. But wait, isn't there already an article on this??? ...

• Print Areas | Print Area Regions

  Introduction Regions allow a specified portion of a print area to be cloned and re-applied elsewhere on the print area. They are often utilised to create mirroring or stretching effects. Important note: Regions are currently only supported in the ...

• Print Areas | Options (Advanced) > Adding Print Effects

  Overview The general purpose of Print effects is for incidences when the print output needs to be visually different to the app preview. So for instance, let’s say the personalised product you are creating is a tumbler or wine glass that you can add ...

• Print Areas | Print Layouts - The Basics

  Overview A Print Area Layout allows the user to combine multiple outputs (from several defined Print Areas) into a single ‘Merged’ output file. This is often needed to meet specific fulfilment requirements. It can also be used to repeat the output ...

• Image Areas | Options > Fit Mode

  Please note that Fit Modes have been updated and as of 2022 there are 3 additional types which are detailed below - These types are Relative, Relative Contain and Tile. Top Tip: Watch on full screen for best quality / viewing experience! Please note ...